The RSR runs a free of charge classified advertising system on this web site. All adverts are held for moderation, if approved they will appear on this site.
For more information click here.
Classified Ads
RSR Forum posts- Rover History • Rover dealer notepad holderOn a car run yesterday, a fellow local member produced the item in the attached photo for me. It is a notepad holder, presumably for a salesman to have on his desk. As he was giving it to me, another club member appeared with an item for me which I immediately recognised as a Rolls […]SHyslop
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: rover 10 p2 steeringThere were several different drop arms fitted to Rover 10s over the years. 59246 in 1934, 01134 in 1935, 40461 in 1936 - 38, 42696 in 39-46 then 212737 in 1947. The coupe had a separate part no, 42697. These are not necessarily common to the other Rover models so the chances of finding exactly […]SHyslop
- New members • Re: New Member in DorsetHi Mike,Can you let me know how I go about ordering and paying for the P2 workshop manual please. I'm a bit stuck without it at the moment!Many thanks.Regards,WilliamBurgundy
- Wilks' cars P1 and P2, thats cars up to 1947 • rover 10 p2 steeringThe drop arm snapped on my Rover 10 (1939) luckily I wasn't driving so no harm done. A replacement arrived from Mike Evans that was an inch shorter than the one that had snapped. The replacement fitted and the ball joint to the drag link was above and just behind the axle. The old drop […]ANDY
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Dynamo removalDear David,I have been the past week sorting a non charging issue. The root of the problem was a newish loom which was not quite the right one for the car then a friend needed a failing RF95 replaced with an RB106 and separate fuses. While doing these I was thinking of your question.That front […]SHyslop
- New members • Re: New Member in DorsetThanks Mike. Have sent you a direct message (I hope!)Burgundy
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Starting ProblemsYou may have already done this but, if not, I suggest draining all the petrol from the tank and running the engine until it stops to ensure there is little or no fuel left in the system. Then refill with a couple of gallons of E5.I have found in recent years that unleaded fuel deteriorates […]TonyG
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Starting ProblemsI was just thinking about your car as I carry out a rewire , plenty of time to think ! If you hadn't said that the car was going all right at times I would have suggested the plug lead order. 1243 is a slightly unusual order, used by Riley and Rover, whereas 1342 was […]SHyslop
- New members • Re: New Member in DorsetHello William, the latest edition is being reprinted but we can supply from limited stock at £32 to addresses in the UK. Please advise me if you wish to order.Best regardsMikeGOY189
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Starting ProblemsSHyslop, to answer your questions:1) I had previously checked the carburettor and all seemed to be OK with the operation of the piston, so I don't think it is that; but worth another check. When I was checking the mixture setting the piston was falling back OK and no catching anywhere.2) As for sticking valves, […]AFPU
- Rover History • Rover dealer notepad holder
