Classified Ads
RSR Forum posts- RSR Discussion • Re: Hand tools P2 etcA plug spanner is listed separately, but it does seem logical…however a long tubular plug spanner is not suitable for removing plug no 4 as it catches on stuff on the bulkhead on my car! Ref. Manufacturers, my post isa bit misleading in that Snail etc I think only made/ branded the open end spanners…or […]David2021
- RSR Discussion • Re: Hand tools P2 etcI thought I had better look and see what tubular spanner I had in my tool kit. Unfortunately it turns out to a double ended one made in Japan for Draper! (7/16"AF x 3/8" AF) And it is part of a 4 piece set which I can't remember acquiring. I suspect the original would have […]RobHomewood
- RSR Discussion • Re: Hand tools P2 etcSounds logical…“Someone” will surely know about the tubular one!I think they were mostly made by Snail,but I think Superslim also were used, but I may be mistaken DDavid2021
- RSR Discussion • Re: Hand tools P2 etcIn the general notes at the front of the parts book it states that the sizes of nuts and bolts are BSF unless otherwise stated. I was about to assume that the same applies to the spanners in the tool kit. However, I went and had a look at the tools in my car. These […]HAD501
- RSR Discussion • Hand tools P2 etcThere is quite a lot of information on this site, but I have a basic question.In the tool list in the workshop manual there are spanners 3/16x1/4 (2705): 5/16x 7/16 (2706) (both open end) and 3/8 single end (2712).There is also a mysterious box spanner (52485) size unspecified! as well a a plug spanner & […]David2021
- Rover bicycles and motorcycles • Re: RUSTY ROVERHow is it getting on? Any metal under the “superficial “ rust ?DavidDavid2021
- New members • Re: P4 . 75 . 1958 & Twelve P2 Tourer 1948Welcome to the club!My experience in Germany a couple of years ago in June/July with my 12 tourer (#110) was very good…apart from two flat tyres, which was really my fault (long story involving old inner tubes). I cruised happily at a genuine 60mph on the Autobahnen with a bit of speed in hand. Of […]ThomasMoRo
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Technical data for Twelve P2 TourerHello ThomasHere is a photo of a page from a well-known book on classic Rovers. I hope it'll be legible!As far as I know, there is little difference mechanically between the Tourer and the 1947 Saloon and Sports Saloon, so you may be able extract some useful information.Best of luck anyway, DavidMWIN_20240508_15_57_01_Pro.jpgMany thanks for the […]ThomasMoRo
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Technical data for Twelve P2 TourerHello ThomasHere is a photo of a page from a well-known book on classic Rovers. I hope it'll be legible!As far as I know, there is little difference mechanically between the Tourer and the 1947 Saloon and Sports Saloon, so you may be able extract some useful information.Best of luck anyway, DavidMWIN_20240508_15_57_01_Pro.jpgMany thanks, David.But the […]ThomasMoRo
- Wilks' cars P1 and P2, thats cars up to 1947 • Re: Technical data for Twelve P2 TourerHello ThomasHere is a photo of a page from a well-known book on classic Rovers. I hope it'll be legible!As far as I know, there is little difference mechanically between the Tourer and the 1947 Saloon and Sports Saloon, so you may be able extract some useful information.Best of luck anyway, DavidMHAD501
- RSR Discussion • Re: Hand tools P2 etc
